Taber 磨料填充機滿足的測試標準
|
Reference |
Title |
Scope |
|
ASTM F510 |
Standard Test Method for Resistance to Abrasion of Resilient Floor Coverings Using an Abrader with a Grit Feed Method |
This test method covers a laboratory procedure for determining the abrasion resistance of resilient flooring using an abrader with a grit feeder. |
|
EN 655 |
Resilient Floor Coverings-Tiles of agglomerated composition cork with polyvinyl chloride wear layer-Specification |
This European standard specifies the characteristics of agglomerated cork with a wear layer based upon polyvinyl chloride and modification thereof. |
|
EN 660-2 |
Resilient floor coverings - Determination of wear resistance - Part 2: Frick-Taber Test |
This European Standard describes the Frick-Taber method for determining the wear resistance of the wear layer of polyvinyl chloride floor coverings under laboratory conditions. The test method is applicable to floor coverings with smooth surfaces. It can be used to determine the wear resistance of surfaces against abrasion and particularly for ranking different wear layer types within one type of product. |
|
EN 14354 |
Wood-based panels - Wood veneer floor covering (Annex D) |
This Annex specifies a test method to determine the resistance to wear of lacquered wood veneer floor covering . |
|
ISO 24338 |
Laminate floor coverings - Determination of abrasion resistance |
This International Standard specifies two methods (A and B) for measuring abrasion of laminate floor covering elements. The tests described measure the ability of the surface layer to resist abrasive wear-through. The resistance to wear according to method B is evaluated by abrading the face of test pieces with a specified abrasive applied by means of two loaded wheels. The number of revolutions of the test specimen required to cause a defined degree of abrasion is measured by both methods. |
|
IKEA Spec. No. IOS-TM-0002 |
Surface Resistance-Test Methods (section 9) |
Description of a method that measures the ability of a coated surface to resist abrasive wear-through to the underlying substrate by assessing the resistance to liquid paraffin (fat) in the abraded area. The method is used on coated wood, foiled and laminated substrates in applications where high surface resistance is required. |
注意：進行以上標準的測試可能需要結合配件一起使用。
粵公網安備 44060402000050號